It's simple. The patent-pending Billboarder Framing System™ comes in 8-foot lengths. Each 8-foot length comes in two pieces; the base plate and the cap. Self-tapping screws and compression rubber gaskets are also included. Using the long screws provided, you attach the base plate to the truck or interior or exterior wall. You insert the compression rubber gaskets into the gasket trap of the base plate; you only need to insert the gaskets the first time you install the base plate, not every time you change the banner. You temporarily tape the banner to the base plate with super-easy-to-remove duct tape. You hook the anodized capping plate onto the outside edge of the base plate, and screw the cap to the base plate using the short screws provided. The compression rubber gaskets compresses the banner against the capping plate, and holds the whole banner securely. The short screws bring the inside edge capping plate completely down to the wall, tightening the banner. You're done with your initial installation!

Changing banners is easy, and a major feature of the Billboarder Framing System. Just remove the capping plate, undo the duct tape by pulling the banner off, roll up the old banner for future reuse, and repeat the process above to install your new banner!